Hi there. today my receiver lost signal. so perhaps because of which im not getting any channels at all. Im in Oak Park, IL. my setup is as follows: Satellite = Echostar 3 61.5W LNB Power = ON LNB Type = OCS-DP LNB Freq. = 11250 (no matter what I choose, dont get any signal) 22Khz = ON TP Freq. = 12676 (again, no matter what i choose, dont get any quality signal) DiSEqC 1.0 = None motor = Off Legacy SW = None
any help anyone can provide to get me up and running, i would very much appreciate it
Posted on Sunday, April 20, 2008 - 10:30 pm: Edit Post Hi there. today my receiver lost signal. so perhaps because of which im not getting any channels at all. Im in Oak Park, IL. my setup is as follows: Satellite = Echostar 3 61.5W LNB Power = ON LNB Type = OCS-DP LNB Freq. = 11250 (no matter what I choose, dont get any signal) 22Khz = ON TP Freq. = 12676 (again, no matter what i choose, dont get any quality signal) DiSEqC 1.0 = None motor = Off Legacy SW = None
any help anyone can provide to get me up and running, i would very much appreciate it
best regards,
change the following
lnb type from ocs dp to standard or single 22khz from on to off diseqc from none to 3 you will be back up
PARKER YOUR S HAS TO BE VERY HIGH. IF NOT THAT MEANS YOU HAVE NO CONNECTION BETWEEN YOUR BOX AND THE DISH. CHECK YOUR CABLE CHECK YOUR COONECTION . ALSO COUPLE OF TP HAS NO SIGNALS SO DONT WORRY ABOUT THAT ,.
MAKE SURE OF WHAT TYPE OF LNB YOU HAVE . EITHER STANDARD OR DP
LNB FREQUENCY IS ALWAYS 11250 THE PORT NUMBER IS NONE CUZ U ONLY HAVE ONE DISH . I BET YOU HAVE CONNECTION PROBLEM
Like Cartier say change come for none and try ocs-dp or standard for signal If not work you can check cable and LNB Reload last bin and after do a hard reboot. Good Luck