Echo 8 help please

 

Bronze Member
Username: Chip_la

Post Number: 16
Registered: Oct-07
I now get echo7 119.Echo8-10 shows on the sat.scan screen with a full signal but I don't get any channels.What can I do to recieve them?
Thanks
Chip
 

Gold Member
Username: Tapeman

New York City in-HD, NY

Post Number: 1782
Registered: Oct-06
Is it showing 110 somewhere as yo change channels?
What receiver are yo using?

Possible areas:
- DISEqC switch
- Antenna setup
- Old bin
- Bad Connector or cable
- Bad LNB
- Dish alignment

Can be anything
Start by eliminating one by one
 

Bronze Member
Username: Nbn3

Post Number: 27
Registered: Nov-07
don't listen to king tapefag, he freely gives bad advice , this time x6

there is a bug in the bin , do a factory default and rescan echo 8.10, works fine. only affects echo 8.. after ur done and watcing ppv on echo 8 you can do all the other 6 things king told you to do. then come back and flame him like a piece of sh*it
 

Bronze Member
Username: Drmunna

Post Number: 21
Registered: Oct-07
king is right,,,
make sure u have diseqc number right,,,,
Sometimes u have all setup right on receiver but u pointing dish to 110,,,,try to find 119,,,,it should always show you correct echo number on top-left screen while you scanning..
 

Gold Member
Username: Tapeman

New York City in-HD, NY

Post Number: 1784
Registered: Oct-06
"Bug in the bin" yoo idiot (nalin bin nadia)
It depends on receiver
Each receiver has its own bin

If it is a bug then it is in the ECM
That is what I detected on October 15th
Called electronic polarity counter measure "EPCM"

I see slowly more people catching up with my predictions

I bet it is a VS product
If it is: then it is part of the EPCM

There are hundreds of people with various VS problems
Many don't turn on and others conflict with polarity
Check TotalFTA as a second opinion
But not too many realy know hardware

This is what nagra has been doing now targeting one product at a time causing distruption to specific products

It is a simple problem that has a simple repair
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us