make sure they are the latest keys. If it is a pansat or fortec (you should give more info) try to turn off and back on from the back. Make sure autoroll is off.
y dont you download the new bin file as LK suggested. Soo easy, no more entering keys! And surely u have been entering keys before... right?? come on dude
menu installation parental control push down 0000 nagra2 Keys 00: enter keys 00 that I provided push to the right on remote keys 01 that i provided Going off memory, I should be close enough for u. I havent had one for a while. Upgraded to VS
Ok I have seen alot saying there units look dead. Here are a few things to try before sending it back to VS.
1. if it's a clone your SOL 2. reboot pc 3. reload factory file
if still no go and you have access to another working receiver then do the following:
1. Load working unit with factory file 2. Once loaded hook up serial cable to dead receiver with power from back switch to off 3. On working unit hooked up to tv do the following:
Menu-> Installation -> Reciver Upgrade
choose main software and click OK (you will see a progress window)
4. Turn dead unit on from back switch 5. The progress bar should start to move indicating dead unit is being programed. If it doesn't check make sure your serial null-modem cable is firmly in place to both receivers and try again.
If the above does not work then your unit is in fact dead... or has a blown fuse.
I have brought a few units back when they seemed to be dead with no front display at all, with these procedures.