New Problem with Pansat 2700a


Hi can someone help me to figure out the problem with my pansat 2700a.
I had just installed the 143 BIN and did some further configurations and it was working

Now it is just saying "Wait For Picture!! (710%" the % isincreasing but no channels....

Can someone HELP!!!!

I seen some thread to installa new BIN please let me know which bin for BEeLL. and the keys????
How can i have auto roll?? and what is that ????//

Silver Member
Username: Lklives

Post Number: 625
Registered: Jan-06
Upload bin 144 released today!..Both Bell and DN work great!...www.dsscommunity.c*om forums has it in Pansat new file release area..

Bronze Member
Username: Kingyousuf

Post Number: 25
Registered: Feb-06
Thanks LK
So i guess i need to do the entire process?

so reset to factory
unzip the file 144 and install using Bl 1.4 or GT loader?

then antenna setup and then Blind scan
and then set to default setting, what does this do???

then are there new keys if i need to do this manully?

but i should turn it off for 2 min and then restart right???


Silver Member
Username: Lklives

Post Number: 628
Registered: Jan-06
NO...just unzip and upload the 144 bin right on top over everything!....then set the deafault key ( it activates the current keys coded into the bin)...then watch TV

If U are missing many channels, ONLY then do a blind scan..

Use either loader...whatever U want or like...I prefer BL 1.4 (my personal GMC over Ford)

No need to reboot (BACK of receiver,2 minutes off/on...turn to channel 300)...only when U are missing channels or have ANY other problems!

Bronze Member
Username: Kingyousuf

Post Number: 26
Registered: Feb-06
greta it works
i had to do the blind csan and reboot for 2 min

now it is working

thanks again
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us