|
New member Username: DnskostaPost Number: 2 Registered: 01-2004 | I ve been reading what anonymous was recommending to similar problems as mine but i seem to get an error i cant figure out what to do. Im using HU 3.5a and COM1 is ready but device not detected. In a site it mentions downloading xpflasher 2.0a would resolve my issue through XPAtmel. When i try program the UL4s through XpAtmel it tells me that no Active Atmel was found...and im stuck.Got no idea what to do. When im reseting the looper under the Atmel code nothing comes up and no programmer could be found is the message i get. My machine is the blue one.Can you please give me the steps of what to do?Thanks |
|
Anonymous | I HAVE MIKOBU 3 AND WHEN I TRY TO BOOT MY CARD IT SAYS ATMEL CODE NOT SUPPORTED.MY ? IS HOW DO I PUT IN AN ATMEL CODE.OR JUST HOW DO I GET IT GOING AGAIN.PLEEEEEASE HEEEELP |
|
dtv masterd starting on dishnet Unregistered guest | if there are dip switches on the loader you have them set wrong mine is 1 and 6 up 2-5 down to program the atmel then 2 & 5 up the rest down to play with the cards |
|
Bronze Member Username: DtvmasterUsa Post Number: 28 Registered: Jan-04 | DISH NET LOADERS FOR SALE!!! 89.99 PLUS 9.99 SHIPPED PLUS NEWBEE CD INCLUDED email dtvmaster@aol.com |
|
Bronze Member Username: DtvmasterUsa Post Number: 29 Registered: Jan-04 | Dtv loaders 79.99 plus 9.99 shipped email dtvmaster@aol.com |