I tried to scan the channels this morning and it got stuck while "save and exit" so tried to switch off the power from the back of the receiver and when tried to on it shows "reboot" on the front display of the box and then it goes to "------". Can switch on/off the front power button or do any thing with the remote. Need help, please.
MrGreg is the Ecoustics clown. If you have ilink 2.84 bin installed, during your conversion to Ilink, you can convert back first to Nano2, then back to Ilink. Note that currently you may have the following changes due to conversion to Ilink Remote control : coloured buttons shifted to the second row from the bottom.
Its was working fine after i converted it. I tried to scan the channels by changing the frequency and there it got stuck. I am tryiny to off the button from back and re-on it in, it shows on the diaplay '------' where it shows the channel numbers normally after the green button switch off and 'boot'
in most cases reloading the software will fix the problem ( it does with other brand stb's) ...with a box converted to use anothers software you may need to start from the beginning.
Its was working fine after i converted it. I tried to scan the channels by changing the frequency and there it got stuck. I am tryiny to off the button from back and re-on it in, it shows on the diaplay '------' where it shows the channel numbers normally after the green button switch off and 'boot'