Pansat 3500 !! no 61.5 channels

 

Bronze Member
Username: Dangrafm

Post Number: 28
Registered: Feb-06
Can someone please help me? I am getting 110 and 118 all channels, I am getting scrambled or noginal when I want to see the indian channels.
my setting are as follows
110 on diseq #4
118 on diseq#4
61.5 on diseq#2
I get 87% quality on diseq#2 for 61.5.
Other setting are
LND type standard
22 mhz: off
 

Platinum Member
Username: Nydas

Post Number: 13738
Registered: Jun-06
You are getting 119 and 118 on one DisEqc Port#4. Your 110 is probably on Port 2. Look for 61.5 at Port 3 or possibly at #1.
The usual connections for a generic (non-DN) 118 LNB are
Port 1 or 4 for 118 and 119, port 2 for 110 and port 3 or 4 for others such as 61.5. The Antenna setup must match the Physical connections at the switch.
 

Bronze Member
Username: Dangrafm

Post Number: 29
Registered: Feb-06
I am sorry it was a typo
My Echo 7 is on #4, Echo8 is on #1 and Echo 3 is on #2. Also when i am doing a blind scan i canot get all the channel on Echo 3 i am only getting 97 where before I use to get 100+
Also y cannot i see the channels, it says no signal or bad or scarambled channels
 

Platinum Member
Username: Nydas

Post Number: 13739
Registered: Jun-06
"on Echo 3 i am only getting 97" That is nothing unusual. It has gone down from about 130 to under 100. More HD channels now. Look at Lyngsat and you will understand. Many of 61.5 channels are moving or have moved to 118.7.
"no signal or bad or scarambled channels"
With the new full EMU BINs, you have to delete all channels, install factory BIN and then the latest 307. Then do the scans.
 

New member
Username: Nyd_us

POST: 16269

Post Number: 2
Registered: Jan-09
You are getting 119 and 118 on one DisEqc Port#4. Your 110 is probably on Port 2. Look for 61.5 at Port 3 or possibly at #1.
The usual connections for a generic (non-DN) 118 LNB are
Port 1 or 4 for 118 and 119, port 2 for 110 and port 3 or 4 for others such as 61.5. The Antenna setup must match the Physical connections at the switch.
 

Bronze Member
Username: Dangrafm

Post Number: 30
Registered: Feb-06
Hey Nalin Thanks for your great help, I did a factory reset and scanned all the channels again and all of them are working. I more stupid question. How do i scan for channels on 118.7?
right now I am getting Eho 7, Echo8.6. i appolozige in advance if I cam asking too dumb questions.
 

Platinum Member
Username: Nydas

Post Number: 13742
Registered: Jun-06
Khan: There are two prerequisites to getting a 118.7W (Anik 3) where a lot of Internationals are.
1. 33" Dish
2. A special LNB designed to get 118 and 119, e.g. CB2008A or Digiwave DGL1189s Linear/Circular LNB for 118/119.
If you have all this then point to 119, use the same DisEqC setting as 119 ad do a blind scan using LNB freq 10750
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us