have a clone flu that had b75---used ukr complete conversion to puff, it keeps scrolling puff across and will not stop,and can;t get it back to b75,,,,how can i get it back, or finish the conversion,,,thank you
1. Download the full PUFF kit. 2. Do a "revert to 2500" using the b60 boot from b60 subdirectory. Make sure you use Chancey's special loader for this and set it to boot. 3. Using BL updater install the OLD 294T BIN from the b60 subdirectory. 4. Then continue as per instructions for PUFF conversion in the main "instructions.doc". 5. After you have installed the latest PUFF_294 BIN, 6. You will still have to do user setup. 7. Then do at least one antenna scan. 8. continue on and do all antenna scans.
I hope you know your antenna setups. Get the full kit from one of the following URLs: [link removed]
Download and unzip into separate directory. PLEASE DO NOT ATTEMPT WITHOUT READING INSTRUCTIONS.
That is what you are supposed to get. Now install the old 294T using the file in the b60 directory and the BL 1.4 updater.
These are the instruction in the instructions file which you are to execute.
"6. You will see horizontal night riders. DO NOT PANIC. 7. Close the 2700 to 2500 conversion loader and 8. Start BL Updater 1.4. Select 294T BIN. Get redy to click 'Write' 9. Turn receiver Off and On, and as soon as it starts with the horizontal bar or even before it starts with the bar start 'Write'. Wait for 'BURN' to finitsh and the receiver to come to 'ON' state . 10. KEEP RECEIVER ON. "
There are more instructions in the the file to carry you through the full installation. Full_KIT_PUFF_294A\INSTALLING PUFF BOOT AND BIN.doc