|
New member Username: Pa1000Post Number: 1 Registered: Sep-08 | I just bought a used FLU. It appears to have the factory bin on it but when I try to load any bin to upgrade it including the factory one I downloaded i get a write failed. anytime I try this if the flashing bootup light will go very slow and the unit will not bootup until I turn it off and on again. if I wait to try writing until ON comes on the reciever the setup screen becomes mostly black and and once it says write faild and I press cancel the unit reboots. so it is communicating with the reciever it just will not write a bin file. I was using blacklist stb updater 1.4.0.0. and the fortecstar stb updater and this is the factory bin I tried loading I posted this on another forum here |
|
Bronze Member Username: Getmo96Post Number: 48 Registered: Jul-08 | Try reloading the boot with the tool/files in jvvh_team PUFF Boot BG link. Tronics 421 loader doesn't need a reset to kick in. If you havent converted to PUFF yet, may try this, the full kit is also there too. *What is the Baud rate set for the com1 port of the PC in the Device MGR? 115200? |
|
Bronze Member Username: Getmo96Post Number: 49 Registered: Jul-08 | I think reading the instructions in the Methods doc for conversion at the link above may clear your issue. Start fresh with a new boot. |
|
Bronze Member Username: Getmo96Post Number: 51 Registered: Jul-08 | After you finish read this thread, if you are needing ant answers about loading bins. https://www.ecoustics.com/electronics/forum/home-video/515510.html |