Bronze Member Username: GolbolePost Number: 26 Registered: Sep-06 | I had a dead pantec ultra for some time (over a year), which i decided to revive. After doing lot of search, i ran into a good post which had three files - a Jtag file - 2500 to 2700 conversion - puff conversion. I followed the instructions and it worked. loaded latest Puff bin(276) in the end. It worked for couple of hours and then unpluged it from main, to move it to another room. But, surprisingly, when pluged back there were no lights again. tried different power outlets but its again dead like it was before. Please help. I've been reading for few days now, but couldn't get anywhere. |
Gold Member Username: PlymouthQuebec city, Quebec Canada Post Number: 2865 Registered: Jan-08 | jas check capacitor on power supply and replaced it Check this thread on it: https://www.ecoustics.com/electronics/forum/home-video/497123.html#POST1571916 |
Bronze Member Username: GolbolePost Number: 27 Registered: Sep-06 | Thanks Plymouth, I checked the capacitor. It's fine. I'm just wondering is there a file i can trying flashing it with. I didn't saved the one I used to flash it before. and I don't know where I found it. |
Silver Member Username: LetmeonPost Number: 237 Registered: Mar-06 | Everytime You unplug and plug it in again the unit goes thru a cold boot..... P ...U....F....F , stays on last F for awhile then shows channels. I have Pantec Ultra with PUFF and no problems. Try loading PUFF 276 again. |
Silver Member Username: LetmeonPost Number: 238 Registered: Mar-06 | Just looked at the files U used. The conversion is actually 2700 to 2500. Try the conversion again BUT make sure it is 2700-2500 (this is only if before it was a 2700 clone, if it was 2500, ther is no need for the 2700-2500 convert. Hope this makes sense..... |