I am using sat 148, my receiver is viewsat ultra v2, I auto scanned 148 and it found ZGUJ and ZPUN on freq: 12588 but it does not come up, signal is at 94 percent but quality at only 23 percent, I have read some post were it says I should add new tp 12542 ,I tried but it did not work, I tried blind scan but it picks 12588 for this channel, I am not sure what I am doing wrong but if some guidance/direction would be greatly appreciated.
Thanks for your reply Here is how I have my set up, Dish 500 with twin legacy lnb and Dish 300 (148W) with single legacy lnb, three wires , 2from Dish 500 are conncetd to Disqswitch port 1 (110) and port 2 (119), Port 3(148).