Bronze Member
Username: Juchito97

Post Number: 51
Registered: Jan-08
i just install a dish 500 my self with DP plus, i got 90% quality and 90% strenght on LNB1 but nothing in LNB2, and in LNB1 it say found 110w (not 119w) so what i do from here? all my setting are correct.

Gold Member
Username: Nydas

Post Number: 9250
Registered: Jun-06
You might be 9 degree off - too far East. You may be pointing to 101/110W now.

Bronze Member
Username: Juchito97

Post Number: 52
Registered: Jan-08
right now i got my stb working 100% but with 110w only, i moved the dish right,left,up and down and nothing , omg, i dont know what to do, i need 119w.

Bronze Member
Username: R_d_g

St. Louis, Missouri

Post Number: 17
Registered: Aug-07
Try this. Put a single coax on the 119 side of LNB. This is the one on the right when faceing the dish. It should also say 119 on your y adapter. Tune in 119 the best that you can, and then switch to 110. If scew and elevation is correct you should have both with aprox. the same strength. GOOD LUCK

Silver Member
Username: Madflea168

Post Number: 342
Registered: Jan-08
check for alignment.

run cable from lnb to box directly to make sure the antenna is at the correct position.

bring tv/box out near the antenna for fine tuning if needed.

good luck.
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us