|
Bronze Member Username: Candy1Post Number: 22 Registered: Oct-06 | African i have Lmb on Lmb Type standard Lmb Freq 11250 22khz off TP Freq 12224 Diseqc 1.0 port 1 Echostar port 2 Nimiq 1,3 motor off Legacy sw none I need to program echostar 7 and the other Bev on 3 and 4 i have two dishs and four Lmb's only the two are programed in the receiver |
|
Gold Member Username: KirankumarI will not b... Post Number: 2122 Registered: Oct-07 | turn receiver OFF form back ,always do this when you are hooking or unhooking cables. go to switch outside and hook up echo 7 to port 3 and b@v to port 4. turn receiver ON from back, then go to antenna settings and bring up echo 7 and put the same settings as others,but change the Diseqe port to 3 and that should give you good signal and quality for echo 7,if it does not then change TP freq slowly until you get good strength,once you get that do auto scan. then do the same for b@v but change port to #4 please post results or questions |
|
Gold Member Username: KirankumarI will not b... Post Number: 2123 Registered: Oct-07 | you will be able to program b@v but you will not get picture until new bin comes out,there has been a new ecm by b@v |
|
Silver Member Username: PlymouthQuebec city, Quebec Canada Post Number: 882 Registered: Jan-08 | African Bev and Dish work fine on VS Ultra Why you says that? |
|
Gold Member Username: KirankumarNO Bashing Post Number: 2130 Registered: Oct-07 | sorry, buddy i am running sonic view only,so i a haven't tested c00lsat or viewsat today i read post and did not want, Annspring to panic |