Hello.. (I have a Pansat 3500sd) I am currently viewing bev which works fine, i have setup another dish to receive echo 110 119. I installed a DiSEqC switch B3v going into lnb 1, dn going into lnb 2, and the other into lnb 3 and the cable going into receiver... When i scan Nimiq 1.3 it says 0 program found and when i scan the 110 119 it also says 0 program found.. When i disconnect the dn and the switch and re hook b3v only and re scan the satellite i get programing on b3v. I have checked the dual lnb on the back of my receiver to make sure they work and i get good signal...any suggestions on how to make everything work. thanks
In antenna settings Are yo assigning DISEqC settings to match your LNB config?
What I would do when I have multiple satellites - With receiver turned off - Connect each Sat from respective coax cable via coupler - i.e. no DISEqC switch yet straight from LNB to receiver via coaxial coupler instead od DISEqC switch - Turn receiver on then scan that satellite - Step and repeat to second and third sat etc.
- When I finally load all 3 sats - Once again turn off receiver - Connect all 3 sats to DISEqC switch - Turn receiver on - In antenna settings assign each respective Sat to match DISEqC port
Bugsbunny Yo want to learn correctly I gave yo a step by step instructions Follow it and ask questions based on what I gave yo
Jo elias If yo have a question Create a thread as it is the forum rules To be able to provide accurate reply to each member 91 on one dish 110/119 on a second dish One DISEqC switch yo may use any of the inputs on DISEqC switch But must match DISEqC cable order to antenna setting ports
If yo are in Canada I recommend to use 91 as port-1 But it realy doesn't matter as long as yo are aware of the order
Thanks all of you's who have answered my question.. i will do the best i can and follow the instructions given..should i be stuck I will start a new thread if thats ok. thanks again