CaptiveWorks 700s

 

Bronze Member
Username: Agf

Post Number: 61
Registered: Aug-06
Since this receiver is new and have not seen any info on this. Need info on what is the current Bin file, which files to upload, review etc.
Appreciate all the help we can get)

Thanks
AGF
 

New member
Username: Signalfta

Post Number: 3
Registered: Dec-07
This what i found for the latest bin
CW700SV1.39_2007_12_24
Fix Freezes and Remote Response
 

Silver Member
Username: Brucester

Post Number: 892
Registered: Jul-06
AGF the new bin is 139 and this is what i found at dssrookie dot com How-to: CW-700S USB or Cable Setup Guide

--------------------------------------------------------------------------------

USB Instructions

Download and Unzip latest bin file.

Transfer unzipped file onto USB stick then plug it into the box. You should see a message that says USB ready. Now press the USB button on remote and then scroll to the right to open the Software tab. Look for new file and press OK to load it. After it loads, it will ask you if you want to reboot, say YES.

When it reboots then go in menu and do a Factory Default. Then reboot again from the rear power switch. When it comes back up again, now you can setup satellites and options and rescan all satellites. After that is done, exit out of all menus and with the remote press F1 000 to enable the Patch. You should see a message on your tv that will say PATCH ENABLED. Now wait for keys to roll and watch tv.

Cable Instructions

To Prepare Receiver:
Turn off and attach the null-modem cable between the receiver and the computer serial port.Then plug in the power plug.
With the CaptiveWorks 700 receiver off, press the front power button and hold it.
While holding it, turn the rear toggle switch on, while STILL holding front power button.
You will see "boot" on the front display.

1. Download the current loader - New CW-700S Upgrade Loader and unzip
2. Download the latest bin and unzip this file
3. Load the latest bin with the current loader as per these instructions:
Open the loader, select the latest bin in the "File" bar across the top.
For Options, select Download S/W.
To select a port, choose your COM port (usually 1). Then hit the start/load and wait for the receiver to display "-end". At this point, turn receiver OFF from the rear switch to reboot.You can now follow the last paragraph in the above USB instructions to help setup satellites and scan channels.

thanx goes to the author.

_____________________
btw i couldnt post in the how-to section...so maybe a mod can move this to proper section..thank you
 

Bronze Member
Username: Agf

Post Number: 62
Registered: Aug-06
Thank you Bruce, you are so quick and to the point. Also thanks to the author. You guys make the world a better place.


 

Silver Member
Username: Brucester

Post Number: 893
Registered: Jul-06
glad to help have a nice day
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us