My bros been having problems flashing a bin into his SV1000, this occured when the latest(271) bin was released and never had any issues before. I told him to do a factory reset, load the factory bin, do a hard boot... Still nada.
He says it gets stuck at 1% then goes back to 0.... then said unsucessfull.... He then hooked it up to tv and did a factory reset.. 3x.. still no go...
With the latest Sonicview 1000 and 4000 BINs, IMMEDIATELY after installation of the BIN is complete, you are required to switch off and after 30 seconds switch on. After that go into menu and recheck your user and antenna settings. Last call I had to a relative was about a similar situation, where the autoroll had been turned off previously by somebody for installing keys manually, and I had to turn the autoroll on.