Two receivers one with ppv one without


New member
Username: Danny364

Post Number: 2
Registered: Aug-07
I have a vs extreme and a pansat 2700a(upgraded with b 75)both connected to same dish on vs i get everything fine but on pansat i am not getting any ppvs i am getting everything else.I tried almost everything no luck. On ppvs i get 80%level and 99% quality but it always say scrambled or bad channel .anyidea or any help? Thanks.

Platinum Member
Username: Lklives

Post Number: 11325
Registered: Jan-06
Missing SOME, not all channels, is usually a scan issue...or a bad cable or connection..or a dish alignment issue...

but since U have ONLY 1 dish and no problems with the Viewsat, then it cannot be an alignment issue

FIRST...try a REBOOT on the Pansat ....using REAR switch, power OFF, for 2-3 minutes, then power ON...see if that solves your fact , ALWAYS REBOOT first, whenever U have ANY type peoblems..

2nd...check the connections again and the cable...

3rd...rescan the satellites U are missing SOME (PPV's) channels from...

New member
Username: Danny364

Post Number: 3
Registered: Aug-07
Thanks LK i did scan it again and i got most of the ppvs.thank again
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us