Need help on superdish 121 setup for pansat 2700a


Silver Member
Username: Micklee11801

Post Number: 111
Registered: Feb-06

I have 2 2700a, superdish for 121, 110, 119 and 91. I aslo have 1 dp34 and 2 diseqc using on the 2700a. My question is very time I try to change to different sat (let say 110 to 121) will get bad channel. I think I did not do the right setting on both receivers.
Can someone give me their setting if you have the same sats and hardwares?

Silver Member
Username: Micklee11801

Post Number: 113
Registered: Feb-06
anyboby? please help!

Gold Member
Username: Satscanner

Beaversbush, Sportsmans P... Great White ...

Post Number: 2213
Registered: Nov-06
I'm not sure how you have your srtup configured [as you don't state].But with 121 super dish,and a dp34 with 2 recievers,and a 4th satnimiq 1/3 this is what I would do.

121w -port1 diseq setting 1
119w-port2 diseq setting 2
110w-port3 diseq setting 3

know you want nimiq 1/3 : on the reciever to reciever output of the dp34 ,install a short coax cable.put that into a sw21 or a 22kz switch on the off/or 13/18v side

On the 22kz port or [lnb/sat2 on the
install your 91w sat coax.

Insatall the coax from your reciever to the 22kz or sw21 sw.
For the bev ant setting : add sws1 switch .If you use a 22kz switch set your setting for 22kz on for bev/91w.
That is for 4 sats.
There are many different switches and combo's availailable but this is simple ,inexpensive and gives good fast trouble free switching and reliability.}

Note: all diseq settings are OFF for bev!
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us