get my pansat 2700 up and running?. boot ver. 6.2 09 jun 2006 Its been awhile since i have watched T.V. I just turned the unit on and I have no signal. Is there any other causes for this other than dish not aligned? The cable is good. I was planning on doing a factory reset, download the latest bin but someone told me that would not work cause latest bin does not have all the needed files. So any suggestions would be appreciated.I am not even sure of the status of Dn and bev tried looking but it is getting awfully hard to find info here. A thread starts as 1 thing and breaks down fairly quick
do a factory reset and adjust ur settings, make sure u have a signal/quality on dn/b3v, if u do them u need to upgrade to new bin to see picture otherwise there's no point, u need to reaim and adjust ur dish,