Good signal Level - 0% Quality - Please help

 

New member
Username: Efudd

Post Number: 2
Registered: Nov-06
I stopped using my Pansat 2700a for a few months and now after downloading the latest bin I can not get any channels. Both 110 & 119 show 75% level but 0% quality. I haven't changed anything else. Any help would be appreciated.
 

Silver Member
Username: Satscanner

NDS Laboratory

Post Number: 105
Registered: Nov-06
Make shure ant set up settings are correct.Lnb freq:11250, set ur diseq settings then blind scan Make shure your dish is still aimmed properly might have moved, been bumped by something?
 

New member
Username: Efudd

Post Number: 3
Registered: Nov-06
Thanks. I don't think the dish was bumped. Here are my settings and still after the Bilnd Scan I get "0 transpounder found", please someone let me know if something is wrong here:

Echo 7(I renamed to Echo 119)
LNB Local Freq: 11250
22 KHz: On
DISEQC: #3
Skew: 0
TP: [1] 12223 v 20.000
Positioner Setting: Disabled
Level: 75%
Quality: 0%

Echo 6.8 (I renamed to Excho 110)
LNB Local Freq: 11250
22 KHz: Off
DISEQC: #2
Skew: 0
TP: [1] 12223 v 20.000
Positioner Setting: Disabled
Level: 75%
Quality: 0%
 

Silver Member
Username: Satscanner

NDS Laboratory

Post Number: 108
Registered: Nov-06
If ur only scanning the the two sats,put ur lnb cable for echo 9 in port 1 of ur switch,echo8.10 in port 2of switch.set lnb feq:11250 which u have BUT set ur 22kzto OFF if ur not using 22kz s witch.Diseq 1/119 diseq 2 110. then blind scan .If ur using a 22kz switch 119 22kz off 110 22kz on all diseq off.ur settings on switch is incorrect yhe way u have them now.
 

Silver Member
Username: Satscanner

NDS Laboratory

Post Number: 109
Registered: Nov-06
Echo7
lnb 11250
22kz off
disec 1
echo 8.10
lnb11250
diseq 2
22kz off

Make shure your cables are in proper ports on your switch to match settings on setup.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us