I have Viewsat extreme, super dish and DP 34 switch setup. The out of the switch comes as a single line into the cable input line, which i have split between my old receiver and my viewsat receiver.
I have loaded the .cha and .sat file which has EchoStar 7 and 8,10 and i manually added Echostar 9 as well to the same file.
Echostar 7 119.0 W LNB On LNB Type Standard LNB Freq 11250 22KHZ Off TP 12370 Search All DiSEqC Port 1 Motor Off Legacy SW None
Echostar 8,10 110.0 W LNB On LNB Type Standard LNB Freq 11250 22KHZ Off TP 12370 Search All DiSEqC Port 2 Motor Off Legacy SW None
Echostar 9 121.0 W LNB On LNB Type Standard LNB Freq 11250 22KHZ Off TP 12370 Search All DiSEqC Port 3 Motor Off Legacy SW None
In the antenna configuration it shows up as Echostar 7 119.0W for all the three sat's and the only channels i get are from that sat. The channels file which i uploaded has the other sat related channels but with nothing but a blank screen.
And sometimes when i do a new file uplaod it resolves to the Echostar 8,10 110.0W and shows only those channels.
I deleted the other sat's and i have just 121 to see if i get the international channels.. but it is not bringing anything for Antenna Setup.
I already checked my dish and moved it as well, and the signal is the same everywhere.