Pansat 2700a - Sat-81

 

New member
Username: Sidney

Post Number: 1
Registered: Mar-06
Was given this Pansat already programmed for Bell Expressvu. Hooked it up 2 days ago and all worked well until this afternoon. All I seem to get is 'wait for picture!!'. Rebooted and turned to channel 300 (read do to this on this site, but not sure if it applies to every reboot situation). This reboot was successful for about a minute and then it went back to 'wait for picture'. Level and quality of signal are 80+ and 99% respectively. Didn't want to muck with settings....yet. Any suggestions?
 

New member
Username: Thenewone

Post Number: 2
Registered: Mar-06
I get the same problem here. I just posted a new message as I am extremely new to this system and its update. I hope we will have some answer!
 

Gold Member
Username: Lklives

Post Number: 1409
Registered: Jan-06
I can help U very easily but I don't support this site so come to the forums at dsscommunity.c*om and post this again in the Pansat 2700 area..
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us