Viewsat signal aquiring problem


Unregistered guest
I have 2 satellite dishes connected to a switch, dish 110 and 61.5. I can watch both of them; however when i power off the reciever and power it back on again, dish 110 starts aquiring signal and it continues to do so until i go into attena setup with in seconds the quality comes up and i could start watching 110. 61.5 doesnt have this problem. i have reflashed the unit and ensured the correct ports are set to the coresponding dishes. Any suggestions?
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us