Help with programing viewast 2000 ultra


Bronze Member
Username: Candy1

Post Number: 22
Registered: Oct-06
African i have
Lmb on
Lmb Type standard
Lmb Freq 11250
22khz off
TP Freq 12224
Diseqc 1.0
port 1 Echostar
port 2 Nimiq 1,3
motor off
Legacy sw none
I need to program echostar 7 and the other Bev on 3 and 4 i have two dishs and four Lmb's only the two are programed in the receiver

Gold Member
Username: Kirankumar

I will not b...

Post Number: 2122
Registered: Oct-07
turn receiver OFF form back ,always do this when you are hooking or unhooking cables.
go to switch outside and hook up echo 7 to port 3 and b@v to port 4.
turn receiver ON from back, then go to antenna settings and bring up echo 7 and put the same settings as others,but change the Diseqe port to 3 and that should give you good signal and quality for echo 7,if it does not then change TP freq slowly until you get good strength,once you get that do auto scan.
then do the same for b@v but change port to #4
please post results or questions

Gold Member
Username: Kirankumar

I will not b...

Post Number: 2123
Registered: Oct-07
you will be able to program b@v but you will not get picture until new bin comes out,there has been a new ecm by b@v

Silver Member
Username: Plymouth

Quebec city, Quebec Canada

Post Number: 882
Registered: Jan-08
African Bev and Dish work fine on VS Ultra
Why you says that?

Gold Member
Username: Kirankumar

NO Bashing

Post Number: 2130
Registered: Oct-07
buddy i am running sonic view only,so i a haven't tested c00lsat or viewsat today
i read post and did not want, Annspring to panic
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us