|
Bronze Member Username: Da_onePost Number: 13 Registered: Nov-06 | I WOULD LIKE TO KNOW IF THERE IS A BIN THAT I CAN USE TO PUT A CAPTIVEWORKS CW-600S. IT HAS BEEN LIKE TWO MONTHS THAT I HAVE NOT USED IT. THANKS. |
|
Silver Member Username: Destine1983Montreal, Quebec Canada Post Number: 185 Registered: May-06 | A good place to look for a bin for your box is in www.dssevolution@com type into your search bar and replace the @ with . |
|
New member Username: SstwiredPost Number: 7 Registered: Jun-06 | Flash CW 600s I Load CW600SV 1.27_autorollfix. Connect your PC and receiver with twisted RS-232C Null modem cable. Turn on the receiver you will see 00:00 and then press "POWER" key on front of the receiver panel to make it standby, the LED dot - - : - - will blink. Note: Loader will not work until you see - - : - - on LED panel Run the LoaderV1.06P on your PC. Select the right COM port where you connected your null modem cable usually COM1, then select <download>, press <open> and select the above bin file, then click <start>, upgrade will begin. After finishing, the LED will display "-End" Exit all menus, Press F1 key; the LED will display 'H', then press '000' to enable patch. Watch TV |