Hello Everyone, I am presently experiencing this problem with my Sonicview 4000 Receiver. The problem that I am experiencing is I am getting NO Signal on my television screen. Whenever I do a blind scan on my receiver, I am seeing all the channels appearing and also my signal strength. When I exit out of the menu, I am getting No Signal appearing on my television screen. I hooked up, another receiver to the same cable coming from my dish, and I am getting picture and also signal strength. I change my LNB type to Universal and Single in thr Dish Setting Menu and it is not working. I flashed my receiver with the Factory bin then with SV4000_V0249P_Charlie_Fixed_081308.bin and it is still not working. My Setup is as follows:
1 12ft Solid Prime focus Dish 2 California Amplifier for Prime Focus Dish 3 Single Cable run from the LNB straight to the Receiver.
I would grateful if you can assist me in having my problem resolved. Thanks in advance.
I don't have proof of this But I'm suspecting newer ECMs designed to cause conflict especially when yo do blind scan
This is what I would do: - Load newest bin - Do factory default - Do not do blind scan - Do channel sat scan or TP scan - Do and test one sat at a time
Hello Guys, Thanks for your suggestions. I am on Echostar 3 (61.5) where I am experiencing this problem. I am living in the Southern most part of the Caribbean.