I have 2 KOLE 1920's(amps), the amps have an RMS rating of 370 x 2channels at 4 ohm, and 440 x 2channels at 2 ohm and 2 audiobahn ALUM10Q (10" sound Q subs) and they have an impedence of 6ohm each and an RMS of 800watts each, i was wondering if someone could tell me the best way to wire the amps and the subs to create the best sound?
loud and low
Unregistered guest
Posted on
i am not familiar with the amp but to match the ohm loads wire the subs in parallel i checked they are dual voice coil subs so by wiring the 2 positives and negatives on the terminals of each sub together your amp will see a 3 ohm load on each channel which will roughly give you the average of the 4 and 2 ohm power ratings. so you will be pushing the subs with about 405 watts each.