Help on dvc and svc subs

 

mil1lion
Unregistered guest
I have a Rockford 4 ch power amp and am looking for one of the new rockford subs. Is it possible to get a DVC 4 ohm sub and bridge both front and rear channels. So as my amp is 275 watts bridgable at 4ohm on both front and rear, i would run one + terminal to the left rear port and the - terminal to right rear port. Then connect the other + terminal to the left front port and the - terminal to the right front port. This way the sub gets 550 watts of its 600 watt peak.

Or do i need to get 2 DVC 2ohm subs and run each in paralel receiving 275 watts each.

Any help would be much appreciated
 

Anonymous
 
You could run it in stereo, and run a single bridged channel to each Voice Coil. Might be going over the RMS per Voice coild though.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us