Need help mmats 500.1

 

New member
Username: Ford_73

Post Number: 1
Registered: 12-2003
i just got a mmats 500.1 does any body know how to brige it?
 

New member
Username: Motoman22

Post Number: 16
Registered: 12-2003
the 500.1 is a mono amp, one channel can't bridge ...or do you have the 500.2?

 

New member
Username: Glasswolf

Post Number: 293
Registered: 12-2003
what are you trying to do exactly?
are you trying to wire two subs to the amp?
Mike's right. can't bridge a single channel amp, but it can handle more than one sub.
 

New member
Username: Ford_73

Post Number: 2
Registered: 12-2003
it says 500.1 butt it has 2 channels i want to drive my 2 mtx 6000 8's
 

New member
Username: Ford_73

Post Number: 3
Registered: 12-2003
they say it's 500watts@1ohm
 

New member
Username: Glasswolf

Post Number: 312
Registered: 12-2003
Ok, that's not bridging. That's just parallel wiring. I figured that was what you meant. I'm used to seeing that mistake, so I catch it pretty quickly.

Yes the two sets of terminals are there to allow easy parallel wiring of two subs to the amplifier. Just because it's a mono amp doesn't mean it can only power one sub. :-)
If you have two 4 Ohm subs, that'll be a two Ohm load on the amplifier.
MMATS is a good company by the way. good subs and amps. Nice choice.

Bridging is when you have a two-channel amp and make it into a mono amp, or a four channel amp into two channels. this is done by enabling a button or switch which inverts one of the two channels to allow the amp's full power to be delivered to a single channel instead of two channels.
www.bcae1.com had lots of information explaining amplifier bridging, how to wire amplifiers and speakers, and so forth.
 

New member
Username: Ford_73

Post Number: 4
Registered: 12-2003
thank you
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us