im looking for a website where i can put in the specs of my sealed box so i can figure out what size in diameter and length of pvc ports i need to tune my box to my desired frequency. thanks again for the help,
my box is 1.0 cu ft im looking for deep bass like 30-40hz help me not have to go buy another box lol
it just told me i need a flare tubed port, but thats the thing i need to know how long do i need to cut the pvc pipe and how big in diamater to get a 33hz tuned box if its 1.0 cu ft 12" sealed already, or if im better of just adding polyfill to my sealed box i just want deep clean low bass not really the upper end frequencies
.where can i get an aero port like that cause i was gonna use 3" pvc glued flush to front baffle, would this affect tuning, and if my box isn't that deep could i add a 90 degree elbow or would that effect it to, sorry to bug
Considering you didn't know the size of the port you were using, I am gonna assume you didn't compensate the size of the box to accommodate the ports displacement. A 3" ID port PVC pipe is gonna have an OD of 3.5"... a smidge of math tells us that a 3" ID port with length of 16.3" will take up about .091 cubic feet.
So your box is going to go from 1 cubic foot, to .909 cubic feet, so this loss of volume in the box due to port displacement will bring the tuning up to about 34.5 Hz.
ok thank you for your help imma get started and take pics and post after its installed, i thought i had my system sold but guess ill stick with it and beef up this crunch system lol. 12inch crunch groundpounder new model 600wrms sub and a crunch 800.2 crappy brands i know it was a weddeing gift but ill make the best outta it. thanks again
so i decided to keep it sealed and im gonna add polyfill, went to home depot then walmart then michaels why is everyone out of small bags of polyfill lol. im going to add a pound and a half to each chamber. hopefully it helps my low end response.