|
New member Username: Pacifica_madnessPost Number: 3 Registered: Apr-09 | well yea u can c that i have dual 4ohm 15 l7 with a 1500bd need any opinions that u may kno about how wat is the best way to wire these puppies |
|
Gold Member Username: 04redmach1Www.rdaudio.net, GA USA Post Number: 2550 Registered: Mar-06 | If you have the single sub you would have been better of with ZX 1000.1 or 1500.1. You will wire sub parallel at 2 ohm on the amp. Kevin |
|
Bronze Member Username: PoprocksPost Number: 73 Registered: Mar-09 | http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&I=42 |
|
Gold Member Username: Hittin1TEAM REVOLUTIONLake Charles... Post Number: 3067 Registered: May-07 | that amp should do more than enough for the L7. Both neg from sub to neg on amp, both pos from sub to pos on amp. no bass boost set gain properly make sure sub is in optimal enclosure if you want it to last. That is a powerful amp. IMO a lil too powerful for a L7 daily.(some will disagree) Unless you are careful with all of your settings, filters, ect.. |
|
Bronze Member Username: PoprocksPost Number: 75 Registered: Mar-09 | RF T1500-1BD 40hm 500x1 2ohm 1000x1 1ohm 1500x1 |
|
Gold Member Username: Hittin1TEAM REVOLUTIONLake Charles... Post Number: 3070 Registered: May-07 | Hook up a couple of subwoofers to Rockford Fosgate's Power 1500bd mono sub amp, and then prepare for the savagery! Rockford Fosgate built this bad boy with patented Class bd technology so it can crank out up to 1,500 watts of continuous power from a remarkably compact chassis. Its 75% efficiency rating means it'll maintain steady power flow and run cool, even under the most stressful situations. The sonic onslaught begins with Punch Bass -- a wired remote gives you flick-of-the-wrist control over system impact (with up to 18 dB of boost at 45 Hz). The variable low-pass crossover (50-250 Hz at 24 dB per octave) allows you to adapt amplifier output to best suit your subwoofer, enclosure, and vehicle acoustics. The POWERsync connector (a 6-pin mini-DIN plug) allows you to bridge together two separate Rockford Fosgate Class bd amps for single unit operation. The Power 1500bd includes a filter that removes all subsonic frequencies (below the range of human hearing) for increased amp and speaker efficiency. Removable end caps give you even more options for installation. Basic Features 150-amp fuse and fuse holder required 4-gauge power and ground connectors Class bd technology NOMAD advanced protection circuitry monitors temperature, voltage, current and impedance, and provides "intelligent" shut-down protection without limiting system performance. POWERsync -- a 6-pin mini-DIN connector that allows you to bridge together two separate Rockford Fosgate Class bd amps Requires 4-gauge power and ground leads -- wiring and hardware not included with amplifier Subsonic filter removes frequencies below the range of human hearing for increased efficiency TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise between the head unit and the amp. Wired remote control of Punch Bass (0-18 dB centered at 45 Hz) -- gives you fingertip control of your bass impact Crossover: Selectable 50-250 Hz variable low-pass crossover, 24 dB/octave Dimensions: 18-1/2"W (13-11/16" without endcaps) x 2-7/16"H x 9-7/8"D MOSFET: MEHSA mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability. Pre-Amp Outputs: Preamp outputs for easy connection to a second amplifier RMS (Continuous) Power: 1500 watts RMS x 1 at 2 ohms RMS (Continuous) Power: 750 watts RMS x 1 at 4 ohms This is what I went by. If it is wrong, them my bad. lol |
|
Bronze Member Username: PoprocksPost Number: 80 Registered: Mar-09 | Yeah there 1ohm stable. |
|
Gold Member Username: Basebalz13Moneta, Va Usa Post Number: 1452 Registered: Aug-07 | does it put out 1500 @ 1 ohm or 2 ohms tho |
|
Gold Member Username: Drant19DUB-C, TX Post Number: 1546 Registered: Aug-07 | if its the older model (1501bd maybe)then im pretty sure its 2ohm. However, if its the T15001bd then its 1ohm |
|
Gold Member Username: Th3pwn3rI compensate... Post Number: 9312 Registered: Jul-06 | Just wire the sub in parallel, all positives together and all negatives together, it will work either way... |