|
Bronze Member Username: BlazerboyPost Number: 82 Registered: Jun-06 | Hey boys, OK well I just got a new Audiobahn a8002v amp to power some RF Punch 12" stage 1 subs. So i basily got the amp becasue i wanted something to ower my crappy RF's but i want it to be able to power a couple 400 rms subs in teh future. But anyway, im looking to give the subs 200 watts rms each for a total of 400rms. Since it has 2x 400W RMS @ 2 Ohms and 2x 200W RMS @ 4 Ohms im pretty sure this could be done since the subs are 4 ohm single VC. But my question is how would i do this? Is it a matter of wiring it different or do i have to just change a setting on the amp? Thanks in advance. |
|
Gold Member Username: RovinTrinidad & T... Post Number: 8594 Registered: Jul-05 | use this & see if u figure it out http://www.the12volt.com/caraudio/woofer_configurations.asp |
|
Bronze Member Username: BlazerboyPost Number: 84 Registered: Jun-06 | well i guess i have it down to this...What would you recomend for my amp? http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&I=41 |
|
Silver Member Username: Killer44Ontario Canada Post Number: 594 Registered: Dec-04 | man thats a two channel amp and what do u mean "what would you recomend for my amp?" dont u have it...and if u saying what do u do, u jsut hook up the subs to the channels and run power/grn/remote wire to amp along with rca's the amp will put out less power when u present it with a higher load, u dont have to change anything...run one sub to each channel like this and you will fine... http://www.crutchfieldadvisor.com/learningcenter/car/subwoofers_wiring.html?subs =1&impedance=SVC4 it cant be any simplier then that... |
|
Bronze Member Username: BlazerboyPost Number: 87 Registered: Jun-06 | Oh ok thanks man. So I can basicly just hook it up normal? Thanks for staying with me on this. |
|
Silver Member Username: Killer44Ontario Canada Post Number: 596 Registered: Dec-04 | yep and then when u will get better subs you will get dvc 4ohm subs and wire each sub to a channel to present the amp with a 2ohm load per channel and then your amp will put out 400x2 @2ohms... |