SoundStream RUB600-4 -- Is it good for my system ?

 

SoundStream
Unregistered guest
Fully regulated MOSFET power supply
RUBI (Rapid-Use Branched Impulse) proprietary power supply topology
STACT (STabilized Apex Current Topology) Reduces power supply stress by 50%
Trident amplifier protection topology
Hawkins Bass Control Proprietary bass equalization topology
IDI (Intelligent Distress Indicator) gives visual indication of amplifier protection status
Harmonic Bass Alignment produces tighter, more accurate bass
Power Grid design optimizes current delivery to and from the power supply
Chassisink Semiconductors are situated between the circuit board and heat sink
for optimal heat transfer
Ultra-Low ESR Capacitance Bank ensures rapid power delivery for dynamic peaks
Drive Delay III A 3-second power supply delay to eliminate "turn-on" pops
Auto High Current matches the amplifier to virtually every load application
Differentially Balanced RCA Inputs optimize noise rejection
Fully Balanced PS-2 Input for the ultimate in noise rejection and improved S/N Ratio when a BLT or BLT4 is used
Continuously Variable Low and High-Pass Crossovers
Independent L/R, continuously variable input gain controls
Symmetrically discrete balanced Class A drive boards for linear performance while driving low impedance loads
Platinum RCA Inputs and Outputs
Platinum Power Connectors
Line Outputs
Tri-mode operation
Warranty 2 Year

RUB600-4
No. OF CHANNELS: 4
OUTPUT (watts):RMS @ 4 Ohms 80x4
RMS @ 2 Ohm 150x4
RMS Bridged @ 4 Ohms 300x2
T.H.D.: >0.05%
SIGNAL TO NOISE RATIO: 10 - 30k
DAMPING FACTOR: >100dB
FREQUENCY RESPONSE: >200
INPUT SENSITVITY (VOLTS):: 0.3 - 5.0
CROSOVER SLOPES:
High-Pass 12dB
Low-Pass: 24dB
CROSSOVER FREQUENCY: High-Pass(Hz) 70 - 160
Low-Pass(Hz) 55 - 220
DIMENSIONS (INCHES): 2.25x17.25x12

I am going to connect it to infinity Kappa 60.5cs and a pair of kenwood 6x9's ...
 

Maxtheamp
Unregistered guest
Is This Amp Any Good? Where would you class it ??? Is It good as the JL 4 channel ??
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us