|
Kenji Unregistered guest | I have 2 12" volfenhag Subs 1000w Peak each, would they be able to handle this http://cgi.ebay.com/VOLFENHAG-2CH-CAR-AMPLIFIER-AMP-2000W-NEON-LIGHTS_W0QQitemZ5 795998316QQcategoryZ18796QQrdZ1QQcmdZViewItem |
|
Silver Member Username: JaackdethUnited States Post Number: 454 Registered: Sep-04 | It depends on several things. 1) what is your budget? 2) Are those subs dual voice coils, and what are the ohms? 3) what is the RMS of those subs? peak does no good! |
|
Bronze Member Username: Dude2k5Roseville, CA United States Post Number: 19 Registered: Jul-05 | Here are the specs. SPECIFICATIONS: 1000 Watts Max Power 500 Watts RMS Power Dual Voice Coils Aluminum Cone Rubber Surround Coated Tinsel leads Double Magnet Structure Oversized Vented 4- Layer Voice Coil Bumped T-Yoke Double Damper Gold Plated Spring Loaded Terminals Aluminum Die-Cast Basket Recommended Sealed Enclosure 1.25 Cubic Feet |
|
Bronze Member Username: Dude2k5Roseville, CA United States Post Number: 22 Registered: Jul-05 | So can it? |
|
Bronze Member Username: Shadow1290Fayetteville, GA USA Post Number: 89 Registered: Jul-05 | SPECIFICATIONS * 2 x 300W RMS @ 2 Ohms Stereo * 2 x 1000W Max @ 4 Ohms Stereo * 1 x 2000W Max @ 4 Ohms Bridged * Tri-Mode Capability * 2 Ohm Stereo Stable * Low & High Level Inputs * RCA Preamp Line Output * Selected x-over HPF/FULL/LPF * HPF: 50Hz - 1KHz * Full: 15Hz - 30Khz * LPF: 30Hz - 500Hz * Adjustable Input Sensitivity * 0dB & 18 dB Bass Boost * Remote Bass Control * 2 Ohm Stereo / 4 Ohm Mono * PWM MOSFET Power Supply * Soft Delayed Remote Turn On * Dual Color Indicator LED (Power and Protection) * Ultra Slim 1 1/2" Height * Blue Illuminated Right and Left Handles * Blue Illuminated Cooling Fan * Blue Illuminated Terminals * Dimension: 13" x 1.5" x 16.75 (WxHxL) Here Are the real specs on that Amp (had to lok hard to find any mention of RMSW) |
|
Bronze Member Username: Dude2k5Roseville, CA United States Post Number: 23 Registered: Jul-05 | So can these subs support the amp? |
|
Bronze Member Username: Shadow1290Fayetteville, GA USA Post Number: 90 Registered: Jul-05 | What are the ohms on the Dual Voice Coild(DVC's) if they are both 4 ohms you could wire the individually in parallel to 2 channels to create a 2 ohm load Subs= 500WRMS Amp= 300WRMS would the subs be able to handle the amp definantley a better qusetion for you to ask would be if the amp can handle the subs http://p079.ezboard.com/fcaraudiotalkfrm27.showMessage?topicID=48.topic that sight is buy GlassWolf and a couple of other pro's in the car audio business soo for that much money you CAN do much better and with thoes amps the RMS wattage is probably OVER rated and will also most likley suffer from overheating unless you run an AirConditioner line into the amp(Now that's a good idea- HUMM) Soo if you stuck on that amp for some reason then yes your subs can handle it but you'll probably be lucky if you get a year or two out of it I'm sure though that glass or issiac could clear up any other issues that i missed or overlooked and they probably would know just how good or bad that amp is from their experience |
|
Bronze Member Username: Shadow1290Fayetteville, GA USA Post Number: 91 Registered: Jul-05 | SRY to be soo cruel about that amp but in the long run going with a better amp will be better than going the cheap route also it doesn't matter how power the subs and the amp are they haved to be hooked up right be in the right size and type of enclouser (a cheap sub in the right box will sound better than an expensive sub in the wrong box) and how you set up your amp |
|
Bronze Member Username: Shadow1290Fayetteville, GA USA Post Number: 92 Registered: Jul-05 | http://www.onlinecarstereo.com/CarAudio/ProductDetail.aspx?ProductID=14926 this amp(also the one i have) is about the cheapest [High quality] amp to get woch would power 2 500 watt RMS subs very well |