Sub not playing

 

Silver Member
Username: Algirard1

OH United States

Post Number: 120
Registered: Dec-04
OK my amp keeps going into protection mode. I know this is the wrong forum but no one will help me in the amp section. I have a Kicker Kx650.4 that is powering a 15" Atlas and two pioneer speakers. It turns on for a second and plays very very soft, then it goes into protection. I have unplugged all of the speakers and the amp still goes into protection mode. Everything used to work fine until I removed my sub to fix an air leak. When I put it back in it would go into protection. I have checked the wiring and everything. I can't figure out what is wrong. Any help PLEASE!!!!!!!
 

Silver Member
Username: Algirard1

OH United States

Post Number: 121
Registered: Dec-04
I unplugged everything except my power, remote turn on, and ground. The amp still goes into protection. I'm going to try to change the ground and see if that is the problem.
 

Silver Member
Username: Algirard1

OH United States

Post Number: 122
Registered: Dec-04
I tried a different ground location and it is still going into protection. Any thoughts
 

Silver Member
Username: Mike_anthes

Canton, SD USA

Post Number: 118
Registered: Aug-04
u say its powering an atlas...and 2 pioneer speaekers...could you give me the ohm readings on yur sub and pioneers...you could be running the ohms too low...
 

Silver Member
Username: Mike_anthes

Canton, SD USA

Post Number: 119
Registered: Aug-04
nvm i read the rest of yur post and that wouldn't make any sense...
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us