Jonathan. 1600watts/Brahma

 

Silver Member
Username: Mikechec9

Chicago/atlanta

Post Number: 205
Registered: May-05
thanks for the input on the sub burps. david navone suggested that it was probably IF noise, resulting from improper level setting. still working on that issue.

new issue regarding my brahmas-
ok. so, i know that you only really need about 800 watts to effect xmax. and that 1600w is merely a thermal rating.
problem- my two VGA 1600.2 are all i have to work with. the brahmas are 2ohm dvc. so its either 400w/sub or 1600w/sub.

i spoke w/adire tech support, and they suggested .75 ft^3, obviously because of the power that i am using, and the whole "protect the sub from reconing, warranty" issue.

i want to know if i can safely run these subs in 1.5ft^3 with gains adjusted. and will this effect the best low end extention/output for a sealed enclosure.

fyi. i have 0/1 big 3, iraggi 220 (170) amp alt, rux/pxa 701 and strongly considering a kinetic 2400. installing the end of the month. thanks.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us