i need to know which is the best way to set up my system.
I have 7x10 rear speakers, 5x7 front speakers, 10 inch JL audio sub, MTX RT404 amp (specs below) and a MTX RT251D amp (specs below):
MTX RT404 amp:
*Power output: 37.5 watts RMS x 4 (4 ohm load) 75 watts RMS x 4 (2 ohm load) 150 watts RMS x 2 (bridged mono, 4 ohm load)
*Frequency response: 20 Hz-20 kHz *THD: Less than 1% *Signal to noise ratio: Greater than 100 dB *Dimensions: 9.75" W x 2.1" H x 11.5" L *Regulated PWM Mosfet power supply *Defeatable 85 Hz 18dB crossover, selectable for low pass/high pass operation *Smart-Engage auto turn-on/turn off for easy integration to head units *Real-time computerized protection circuitry *2 ohm stereo stable
MTX RT251D amp:
* Semi-regulated power supply causing output to increase as voltage does * 20 Hz--85 kHz frequency response * 100 watt @4ohms, 200 watt @ 2ohms * 18 dB/octave crossover * 8 inch W x 9.75 inch H x 2 inch D
I am wanting to have the RT404 push the 4 speakers and the RT251D to push the sub, is this a good setup? I listen to a lot of rap/hip hop i want a good hard clean thumping bass that shakes my mirrors so i cant breathe.
