What if i wire like this?

 

blackjack2121
Unregistered guest
hi, im curious to know, what would happen if i was to wire one avalanche sub with my kx800.4 like this......
 

New member
Username: Blackjack2121

Post Number: 1
Registered: May-05
Upload
 

Silver Member
Username: Southernrebel

Monroe, Louisiana USA

Post Number: 788
Registered: Mar-04
bad things will happen. one set of channels would give the sub a signal and the other could be trying to give the sub a different single.

not good!
 

New member
Username: Blackjack2121

Post Number: 2
Registered: May-05
oh, well that sucks.... so how would a 15 avalance work with just 400 watts, compared to the 800 i wanted to give it?.....or should i just sell my amp and get a different one?
 

Bronze Member
Username: Mr_wiglz

ManchesterEngland

Post Number: 18
Registered: May-05
I would suggest that you get another amp, and use your four channel to power speakers in the car.

unless of course you can set your amp to mono, in which case you will be able to do it.

just as long as both channels are putting out the exact same signal and not in stereo, then you should be able to do it no problem. a lot of ppl power their DVC subs with an amp to each voice coil. but they have to make sure the gains on both amps are the same. So as long as its not in stereo it should be fine
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us