Sub wiring

 

Bronze Member
Username: Northerncomfort

Sudbury, Ontario Canada

Post Number: 12
Registered: May-04
was wondering what is better.
two 10 inch 4 ohm subs wired for a 8 ohm load for one channel of amp or seperate the subs and have one per channel at a 4 ohm load???
amp specs 760 watts x 1 4-8 ohm accepted
250 x 2 2-8 ohm accepted
 

Silver Member
Username: Lbeckner

Tulsa, Ok Usa

Post Number: 344
Registered: Oct-04
at 8 ohms bridged you should get 380 watts. 2 channels should give you 125watts x 2 or 250 watts total. Try it both ways and see what happens. What kind of amp is it? If its a good quality amp then you might be able to bridge it and get around 1000watts. This may void your warranty, but should be safe as long as you don't over drive it. Depends on the amp.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us