Anyone have plans for a bandpass box

 

New member
Username: Red_devil127

Cumberland, Wisconsin Us

Post Number: 2
Registered: Mar-05
im lookin for a good plan for a bandpass box for my 2 12" folfenhag. they are 500w RMS 1000 watts total dual voice coil. the box needs to sound really good. the box is goin in my room... im also lookin for a good neon light setup for the box so anything that can do to help is awsome. email me or give me a call 1715-671-3048
 

nick_sq
Unregistered guest
bandpass went out with the 90's,lol. Ported box with plexi viewing window would be better...
 

Dat dude
Unregistered guest
illll bandpass
na im juss playin im into sq
 

New member
Username: Red_devil127

Cumberland, Wisconsin Us

Post Number: 3
Registered: Mar-05
ok then do you have plans for a ported box with plexi viewin??
 

Silver Member
Username: Redskin

LondonEngland

Post Number: 130
Registered: Dec-03
So what does a plexi window add then?
 

New member
Username: Red_devil127

Cumberland, Wisconsin Us

Post Number: 4
Registered: Mar-05
Magnet: 160 oz. Double stacked Ferrite magnets
Frame: 5 spoke Die-cast aluminum basket
Cone: Reinforced aluminum curvilinear
Surround: Oversized buytl rubber
Spider: 2 Flat ultra excursion
Power handling: 500 watts RMS, 1,000 Watts Program (conservative)
T Yoke: Industrial Chromed Hex bolt retained, Bumped and Vented
Double damper magnetic motor assembly
Cooling: Double Vented (T Yoke and Motor Side vents)
Voice Coils: 4 Layer Dual 4 Ohm High Temperature black Aluminum
Voice Coil Diameter: 2.2"
Nominal impedance: 4 ohms / per coil
DC resistance (Re): 3.2 ohms each coil
Frequency range: 20 Hz-1.1 kHz
Fs:30 Hz
QTS:.526
QES:.614
QMS:7.698
VAS:56L
SD:.0491M
SPL:90 dB 1W/1m
Xmax:16mm
Mounting Depth: 165 MM
Mounting Hole Dia.:296 MM

That is the specs for my volfenhag subs.... see what you can come up with for a box
 

Silver Member
Username: Fishy

Tamarac Ft.Laud, FL USA

Post Number: 803
Registered: Sep-04
I wouldn't go by any "stock" suggestions. Car and home are two very different enviroments and usually call for different subwoofer allignments. This is one place where WinISD might give you good results.

What do you plan on powering these things with(please don't say a car amp)?

-Fishy
 

New member
Username: Red_devil127

Cumberland, Wisconsin Us

Post Number: 5
Registered: Mar-05
i dont have to put any thing on them for an amp because i have an aduio video reciver that puts out way more than enough power to push the subs. so no i am not useing a car amp.. i have another question for everyone here though. does anyone have an idea for a good setup on neon lights for the box too.. i have a bandpass box already that has a string of neon but i need another box and i want a better setup for neon
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us