How should i wire my subs for desired ohms?


Bronze Member
Username: Gavbo211


Post Number: 29
Registered: Jan-05
I have 3 JL Audio 10w3v2's. they are all dual 4 ohm. is there any way i can run all three together at a 4 ohm total load? im going to bridge them on my Soundstream 2 channel amp (bridged at 4 ohm produces 880 watts.) but the min. independence it can handle bridged is 4 ohms. is there any way to get a 4 ohm total from all three if they are ran together? thanks alot for any suggestions.

Silver Member
Username: Jwbulger79


Post Number: 367
Registered: Nov-04
« Previous Thread Next Thread »

Main Forums

Today's Posts

Forum Help

Follow Us