|
Bronze Member Username: Sony224422Deep River, CT US Post Number: 98 Registered: Dec-04 | is it possible to wire a dual 4 ohm to dual 2 and then put it in a box with a dual 2 ohm and run them off a mono amp with one channel. I want to run a dual 4 ohm and dual 2 ohm alpine r's together off a mtx thunder801d, which is 800 rms x 1 at 2 ohms. Would this work? |
|
New member Username: BigdanmanThe OC, CA USA Post Number: 3 Registered: Mar-05 | http://www.bcae1.com/ figure it out your self. or the12volt.com bot of those have ohm calculation helpers. im too confused from your post to figure it out for you. good luck. |
|
Anonymous | You can get it to work,but not properly. Dual 4 goes to 2 or 8(so 2 in this case) Dual 2 goes to 1 or 4 Anything wiring will not result in equal powering, making problems with cancellation, etc. |