Posted on
Sunday, February 13, 2005 - 23:36 GMT On the ground wire on your amp, where do you connect it to? Do you connect it to the frame of your truck?
Bronze Member
Username: Joebruce KY
U.S.A.
Post Number: 69 Registered: May-04
Posted on
Sunday, February 13, 2005 - 23:41 GMT Yes,make sure to scrape or sand down the paint first so its pure metal and a clean surface this will give you a better ground connection.Then you can just drill a hole and put a bolt in it with the ground wire in between the bolt and frame.Make sure it is a good three feet away from the amp.
Posted on
Monday, February 14, 2005 - 02:36 GMT So I can connect it inside the cab of my truck.
Bronze Member
Username: Marley289 Post Number: 88 Registered: Nov-04
Posted on
Monday, February 14, 2005 - 03:49 GMT yea that would be fine, just be careful that you dont drill into anything like wires, lines, etc
Gold Member
Username: Jonathan_f GA
USA
Post Number: 3229 Registered: May-04
Posted on
Monday, February 14, 2005 - 03:59 GMT Actually, the ground wire needs to be as short as possible, as close as you can possibly get it while leaving a little slack.
Posted on
Monday, February 14, 2005 - 07:09 GMT Do you think I can run the ground wire out my door so I can hook it up to the frame?
New member
Username: D1duck Post Number: 2 Registered: Feb-05
Posted on
Friday, February 18, 2005 - 16:07 GMT any metal part of the body should do fine for a ground connection. i'd not run a cable out the door.