HELP!!! Wiring my amp and subs PLZ!!!!!!!!

nadykto john New member Username: Fatass_tony Post Number: 4 Registered: Jan-05	Posted on Wednesday, February 02, 2005 - 04:22 GMT I purchased one 12" Pioneer Premier TS-W2000SPL which is 2000w MAX and 750RMS, and i also got a 600w JBL amp JBL BP600.1 which runs an Output 2 Ohms: 600W x 1, how do i correctly set up this system to get MAX clean bass out of it.
nadykto john New member Username: Fatass_tony Post Number: 5 Registered: Jan-05	Posted on Wednesday, February 02, 2005 - 04:26 GMT Ogh and it also Outputs 1 Ohm: 600W x 1, so apperantly its one ohm stable, any way to use that to get more bass out of it, im guessing not since the amp is 600watt maz, just making sure.
James Longo Silver Member Username: James1115 Wilton, Ct Post Number: 402 Registered: Dec-04	Posted on Wednesday, February 02, 2005 - 14:49 GMT what is the voice coil configuration on your sub?
nadykto john New member Username: Fatass_tony Post Number: 6 Registered: Jan-05	Posted on Wednesday, February 02, 2005 - 17:43 GMT # Double 4-Layer, Long Voice Coil (2 x 4ohm) # 4-Slit Glass Imide Voice Coil Bobbin # 1-Piece Rubber Gasket # 750 Watts RMS/2000 Peak Power # Dual Voice Coil Design (2ohm or 8ohm) # Frequency Response: 18 - 2kHz # Sensitivity: 89dB (1W/1m)
James Longo Silver Member Username: James1115 Wilton, Ct Post Number: 427 Registered: Dec-04	Posted on Wednesday, February 02, 2005 - 18:22 GMT well you can run it parellel @ 1ohm but you are underpowering them quite a bit. I would get 1 more JBL bp 600.1 and run them both one to each of the subs.
nadykto john New member Username: Fatass_tony Post Number: 7 Registered: Jan-05	Posted on Wednesday, February 02, 2005 - 18:35 GMT You must not have understood me correctly, im only planning to power ONE "12 sub, so i wanted to know if there is a specific efficent way to do it.
nadykto john New member Username: Fatass_tony Post Number: 9 Registered: Jan-05	Posted on Thursday, February 03, 2005 - 00:45 GMT bump
James Longo Silver Member Username: James1115 Wilton, Ct Post Number: 440 Registered: Dec-04	Posted on Thursday, February 03, 2005 - 02:19 GMT ok my bad yes run it in parellel at 2ohms should sound good.
lucas beckner Silver Member Username: Lbeckner Tulsa, Ok Usa Post Number: 258 Registered: Oct-04	Posted on Thursday, February 03, 2005 - 03:25 GMT bump
Anonymous	Posted on Thursday, February 03, 2005 - 04:27 GMT Your info is wrong. The JBL BP600.1 puts out 600W @ 2 ohms, so wire your voice coils in parallel for a 2 ohm load.
James Longo Silver Member Username: James1115 Wilton, Ct Post Number: 447 Registered: Dec-04	Posted on Thursday, February 03, 2005 - 04:34 GMT thats what I said Anon!

« Previous Thread Next Thread »

Main Forums

Forum Help

Follow Us