Bronze Member
Username: Nickadam55 Columbia MO,
Missouri
Post Number: 93 Registered: Feb-09
Posted on
Thursday, February 18, 2010 - 06:14 GMT So i am setting the gain on this amp at home.. i dont have the subs here so, I wanna make sure im not leaving anything out before i give this amp back. subs Fs are 28hz, Set function generator for 28hz put signal in. measure output with scope and adjust gain right under clipping?
Platinum Member
Username: Insearchofbass York,
Pennsylvania
Post Number: 13448 Registered: Jun-04
Posted on
Thursday, February 18, 2010 - 06:32 GMT The typical method used is to use a 50 hz test tone and measure with O scope.
Bronze Member
Username: Nickadam55 Columbia MO,
Missouri
Post Number: 94 Registered: Feb-09
Posted on
Thursday, February 18, 2010 - 06:33 GMT but wouldent i want to set for the drivers resonate freq?
Platinum Member
Username: Insearchofbass York,
Pennsylvania
Post Number: 13450 Registered: Jun-04
Posted on
Thursday, February 18, 2010 - 06:39 GMT if you want to be really picky yes if were talking sealed....if were talking ported id do it at port tune
Bronze Member
Username: Nickadam55 Columbia MO,
Missouri
Post Number: 95 Registered: Feb-09
Posted on
Thursday, February 18, 2010 - 06:53 GMT Yea i believe its 28x12x18(sealed) cacl@ I think about 3 1/2..... so ill tune it to resonate. Thanks sean
Platinum Member
Username: Insearchofbass York,
Pennsylvania
Post Number: 13455 Registered: Jun-04
Posted on
Thursday, February 18, 2010 - 07:17 GMT Your Welcome