|
New member Username: Jkd_360Port Angeles, WA USofA Post Number: 2 Registered: Sep-09 | I have subwoofers- one - Fosgate 12" T1, 600w-rms/1200w-peak @ 2 or 4 ohms (not sure of t112d2 or t112d4) two - Alpine type swr-1242 500w-rms/1200wpeak @4 ohms Amps- Pioneer GM-D510M Class D Mono Peak Music Power 1000 Watts Number of Channels 1 Load Impedance Capability 2 ~ 8 Ohm (Mono) Continuous Power (4 ohm) 300W x 1 Continuous Power (2 ohm) 600W x 1 Continuous Power Bridged (4 ohm) N/A Frequency Response 20 ~ 240Hz and Brutus HIFONICS BXI 1280D Class D Mono 4 ohm 450 x1 2 ohm 900 x 1 1 ohm 1200 x 1 1/2 fard walmart capacitor Wires ran for two amps I currently have the Fosgate/Pioneer setup active. What should I hook to what? I.E. - Dropping ohms bridging, crossover etc. I'm new to this so please help me out. I have custom boxes and can get whatever it takes. Thank you. |
|
Bronze Member Username: JbpittPittsburgh, Pa. Usa Post Number: 73 Registered: Jul-09 | What i would do is wire your 2 type rs to 1ohm like this http://www.the12volt.com/caraudio/woofer_configurations.asp an use your hifonics amp (1200x1 @1ohm) |
|
New member Username: Jkd_360Port Angeles, WA USofA Post Number: 3 Registered: Sep-09 | Perfect! Thank you! |