Like

Opinions on my setup,,,

 

Silver Member
Username: Nissankicker

Grambling, LA USA

Post Number: 308
Registered: Mar-06
As of tomorrow ( Oct. 20,2010 ), I'm putting:
6 12" Hifonics HFD4s
1 Autotek AT-2000.1
Custom Ported Enclosure
... In my 1999 Nissan Sentra GXE ( 4-dr )

My question(s):
1) How do you think it will sound...
2) Do you think it's " overkill "....
3) Etc.....

I will be posting videos and pictures of the entire build & all items...
... I'm just lookin' for advice ( good & bad ), suggestions, etc...

THANK YOU!
 

Gold Member
Username: Gcs8

Atlanta, Ga

Post Number: 1505
Registered: Sep-09
not fond of Hifonics, never heard of Autotek, do you have the power to backup that 2k amp if it does put out rated power. what electrical upgrades do you have? have you done your big 3? got a high output alt? nice battery? 1/0 ga wiring?
 

Silver Member
Username: Nissankicker

Grambling, LA USA

Post Number: 309
Registered: Mar-06
I have Big 3 Installed ( 2 runs of 4ga each )... Stock Alt... ( never had any voltage problems... )... Extra Battery ( Of course! ) - 2 Runs of 4ga wire from Front 2 Back - including Ground ( 0/1 is VERY high in this area - $6 per ft. )
 

Gold Member
Username: Gcs8

Atlanta, Ga

Post Number: 1507
Registered: Sep-09
http://www.knukonceptz.com/productDetail.cfm?prodID=KCA0BK-50
 

Gold Member
Username: Gcs8

Atlanta, Ga

Post Number: 1508
Registered: Sep-09
if if you want copper instead of cca. http://www.knukonceptz.com/productDetail.cfm?prodID=KFX0BK-50
 

Silver Member
Username: Nissankicker

Grambling, LA USA

Post Number: 311
Registered: Mar-06
Thanks for the info...
... NOW BACK TO THE TOPIC ON-HAND!

Advice, Suggestions, etc....
 

Gold Member
Username: Gcs8

Atlanta, Ga

Post Number: 1509
Registered: Sep-09
yes you will have a FUCKTON of cone area but you may do better with 2 larger drivers on the same power. i would also suggest a sundown amp or a audioque amp. those subs probably wont sound that great even tho there cheep ans its easy to just add cone are. however i would love to see this build and what it puts up on a TL. do you have a front stage that will keep up with sub stage?

whats your final ohm load going to be?
 

Platinum Member
Username: Rovin

1 15 = 153 DBs ...Trinidad & T...

Post Number: 16741
Registered: Jul-05
deathoob never hear of autotek = deathnoob



j\p lol

autotek was very good a few yrs ago but now the quality has dropped

hifonics isnt the choice of most of us on E ...
 

Gold Member
Username: Gcs8

Atlanta, Ga

Post Number: 1512
Registered: Sep-09
i would like to see clamped power on that amp, my amp did ~2200 apparently when i when't to the last show, not bad for 2 ohms.

also hush rovin, only been in car audio for ~3-4 years now and only a year or so not failing at it.
 

Platinum Member
Username: Insearchofbass

2 hifonics 2607s, 2dcSounds12xls SPL\idmax12SQ

Post Number: 15633
Registered: Jun-04
x2
 

Silver Member
Username: Nissankicker

Grambling, LA USA

Post Number: 312
Registered: Mar-06
Yes... Right now I have JVC HXs 6.5s Coaxials in the Front stage w/ 6 tweeters accompanying them. - Mid Stage: Interfire Slims 6.5s w/ 1 tweeter each side accompanying them. - Rear Stage: Kicker KX 6.5s.
.... When I figure out what highs amp I wanna use PERMENANTELY I'm gonna install my Component sets ( 5 sets - 1 in each doors - 1 in the rear dash ) Total of 16 speakers & 18 Tweeters )
... But musical wise: It's CRYSTAL clear with the interior speakers I have now on a " Death Wish 360 " ( Old School Amp for the record )...
... I will be posting Pictures and a couple Videos of EVERYTHING - The 6 12s, the Autotek 2000.1, and the enclosure build.
 

Gold Member
Username: Gcs8

Atlanta, Ga

Post Number: 1513
Registered: Sep-09
how about this as a mids and highs amp?

Information on the new SAX-200.4 can be seen hear
Official Ratings off SAX-200.4 :

200x4 at 4 ohms
300x4 at 2 ohms
400x4 at 1 ohm
600x2 at 4 ohms
800x2 at 2 ohms

Actual tested - factory supplied figures :

210x4 at 4 ohms
350x4 at 2 ohms
465x4 at 1 ohm
665x2 at 4 ohms
925x2 at 2 ohms
 

Silver Member
Username: Nissankicker

Grambling, LA USA

Post Number: 313
Registered: Mar-06
That's d*mn good...
... Will keep that in mind ( definitely! )
 

Platinum Member
Username: Glasswolf

Post Number: 13967
Registered: Dec-03
Personal opinion?
it's overly complicated.
 

Gold Member
Username: Loc_out

SoCal

Post Number: 3253
Registered: Feb-05
You might want to upgrade to 0/1. This way you can add more power to them sub's.
 

Silver Member
Username: Nissankicker

Grambling, LA USA

Post Number: 314
Registered: Mar-06
@ Glasswolf... true... but i like complicated.

@ LowLife... Yeah, you are right... I'm gettin' to that as we speak ( type that is )
 

Platinum Member
Username: Glasswolf

Post Number: 13975
Registered: Dec-03
I don't.
too many things to go wrong, too many issues with things like soundstage, imaging, beaming, signal path lengths, cancellation, etc.
Keep it simple and you won't have nearly the issues with getting a good sound system.
I guarantee you I could set up a better sounding system with one 3-way component set in front, one pair of midbass drivers in back, and two subs, all running active.
simple, clean.
 

Gold Member
Username: Gcs8

Atlanta, Ga

Post Number: 1517
Registered: Sep-09
want to play with my car glass?
 

Platinum Member
Username: Glasswolf

Post Number: 13981
Registered: Dec-03
maybe ^^
« Previous Thread | Next Thread »

Facebook

Shop Related Deals

Directory

Main Forums

Today's Posts

Forum Help

Follow Us