|
New member Username: ChampouxPost Number: 10 Registered: May-04 | looking for a source for those really cool looking brass screw down lugs that get attached to the end of a 1/0 power cable and insert into a 1/0 clamp down battery terminal or distro block. basically just like if you tinned the end of the cable, only it bolts on jim |
|
Gold Member Username: GlasswolfNorthWest, Michigan USA Post Number: 3147 Registered: Dec-03 | www.sounddomain.com www.partsexpress.com www.knukonceptz.com |
|
Bronze Member Username: ChampouxPost Number: 11 Registered: May-04 | thanks glasswolf. What I am looking for is similar to the cable reducer/adapters that bolt on a 1/0 cable end and provide a solid lug that plugs into an 8 guage device, only it's 1/0 to 1/0. None of th evendors above seem to carry them (unless I didnt look in the right place. jim |
|
Gold Member Username: GlasswolfNorthWest, Michigan USA Post Number: 3160 Registered: Dec-03 | I haven't seen any ends for just going into a distro block or such.. for that you just use bare wire so the compression clip or screw can bite into the wire |