I am wondering if it is possible to wire "2" DVC 2 ohm subs to run to my amp at 4 ohms. I know its possible for it to happen with one 2 ohm sub at 4 ohms, but I have two, thats the prob. Do you think it would be best to sell my 2 ohm subs and buy 4 ohm subs just so I can wire the 4 ohm subs to 4 ohms. The reason for this is because they dont make a ho alt. for my van and it can not be rewound. If I wire my subs at 4ohm running to my amp then my amp will push 1250 watts which would be better for my battery and alternator instead of 2675 watts that my amp would put out if i hooked my 2 ohm subs up to my amp( since i dont think there is a way to wire 2 2ohm subs to have 4 ohm going to amp). So would it be better to get (2) 4 ohm subs instead of (2) 2 ohm subs?