|
Bronze Member Username: Bobok7787Reedsburg, Wisco Post Number: 60 Registered: Jan-06 | My Diamond D6 has dual 2ohm vc's, and right now its wired in series and my MTX801D(800w@2ohm) can only give the thing 400watts...if i hook up each voice coil to a channel on the amp, and run it in mono, would that work? because then I would be getting the full potential from my amp....thanks for any feedback. |
|
Gold Member Username: Nd4spd18Southeast PA Post Number: 1444 Registered: Jul-06 | That amp only has one channel, and it's 2 ohm stable. The way you have it now is the only way you can wire it. |
|
Bronze Member Username: Bobok7787Reedsburg, Wisco Post Number: 62 Registered: Jan-06 | no its not one channel... i would be running each coil off of the two channels, with a 2 ohm load for each channel, which i think will be alright if i run it in mono...but i need some reasurance...thanks though |
|
Gold Member Username: Nd4spd18Southeast PA Post Number: 1452 Registered: Jul-06 | Well I'm not sure which MTX 801D you have since there are two, but they are both 1 channel mono amps. Here are the specs, see for yourself: http://www.mtx.com/caraudio/products/amplifiers/te801D.cfm http://www.mtx.com/caraudio/archive/2004amps/thunder801D.cfm Just because an amp has two sets of speaker terminals does not mean it has two channels. |
|
Bronze Member Username: Bobok7787Reedsburg, Wisco Post Number: 63 Registered: Jan-06 | So where it says "speaker 1" and "speaker 2" means that its mono...didnt know that, its the older one by the way...thanks |